To Trolsonca. Hope you get this. I have been meaning to get back to you. I have finished my panel programing and everything is working out the way I wanted. I never could get Aux 1 to give any indications on the konnected panel even when my aux 1 output changes state on my voltmeter. It may be defective interface module zone, but did not want to spend $49 to get a new one. Anyway I only need 3 aux outputs for what I want. Aux 2, location 48, event 21 for tell me when armed. Aux 3 event 23 for tell me when ready state, and Aux 4 I made event 7 , for any siren which gives me the indication on Startthings that the alarm has been triggered. I am using the Pushover app to send me text message so I know alarm has be triggered. It works great, which when I first tried I could not believe, but what a relief. I have the siren set for 1 minute which is more time then it needs to send me a text. I did figure out I do not need a armed Stay mode because the NX8 is programed to stay mode if no one leaves through an entry/exit door. So all that time I tried to figured the stay mode out was wasted. I mostly use stay mode and arm panel from my car or outside my house so my dog does not set off the alarm. I also have note on my entry door to remind me to disarm because enrties are instant. Really happy how Konnected has worked out, much time spent but with the results now, it does not matter.