Some sensors not working with 0.85.1

I am replacing an existing Brinks system.  I believe I have everything hooked up correctly and I have 5 zones working fine, but 3 of the binary sensors in my other 3 zones always show up as closed.  If I remove the wires from the zone, the sensor shows up as open (at least the icon changes to open).  I don't see any end line resistors on either end. I have also tried using a magnet to toggle the sensors on and off and that does not make a difference.  I also tried moving the wires to another zone on the other konnected board and it still doesn't work.  How else do I go about troubleshooting this?