Replacement siren is still making clicking sounds

Good afternoon,

I had the issue with my original siren making the clicking noise, so I purchased the recommended Honeywell 2 alarm from the documentation. It’s still making the noise, and if I trigger the alarm, it won’t sound.
Are there specific zones I need to assign to certain sensors? I saw that a motion sensor on zone 5 caused issues in another post, however I don’t have motion, only windows, doors, a sonic, and smoke detector.

Any ideas? My next step is going to be unplug everything and start over. (everything else works fine)

Solved.... apparently the original line was spliced in the wall and crossed over. Fixed the wiring and we are good to go.