New Install

So just got my device last night, I started looking at the help pages and videos but noticing my old panel board looks a little different and more confusing then the others I have seen on the site and youtube. Also I don't have it plugged into power unless it is powered by hardware in the wall. Can anyone assist with where I can start and where my zones are on this board.


Hi.  No expert here for sure but looks like you have zones 1-10 on the left side of the board and then 11-29 on the top.  You should be able to find more information on where the power is supplied by searching on Radionics Alarms.  Good luck.  


A manual can be found here:

Looks like you only have point 1 used (term. 13 and 14) and all the others are bypassed with resistors. (page 8).