Hubitat not recognizing state change

Smart Home Integrations Hubitat
1

I’ve noticed that hubitat wasn’t recognizing state changes on my sensors any longer. Everything was working perfectly when installed a few months ago. If I go to the webpage for each of my (2) Konnected Pro, I can watch the state change when I refresh the screen but Hubitat doesn’t see it. I’ve restarted Hubitat and both KPs a few times but that didn’t seem to fix anything.

Thanks,
Aron

2

Fixed it thanks to a support request and a wicked fast response! Went into the App in Hubitat and saved each of the Pros again and it fired right up. The thought is it may have been an IP address change for the Pros that caused the break in linkage. Support suggested reserving the IP addresses so it doesn’t happen again.

1 Like