My GDO blaQ has been working well since I installed it, but today I noticed it wasn’t operating the garage door. Looking at the logs (attached) I see it continuously rolling codes but not getting a sync. (In this log I tried a couple of times to trigger a door close with the blaQ, but it said “Door already moving in that direction” (which it wasn’t). I then tried closing the door with a traditional opener).
logs_konnected-612024_logs (2).txt (35.8 KB)
The Garage Door is a round yellow button Security 2.0+ Liftmaster, and everything has been fine until today. Any ideas what I can do to get out of this. I have tried restarting the device via the web interface.
Update, this appears to have resolved itself. Will update if it happens again…
1 Like