So, I've been reading through the forums and am excited to get to the point where I am configuring relays and programmable outputs. However, I'm stuck at a much more basic level.
I have an Interface board wired into my Safewatch Pro alarm panel. All of the Zone lights appear to be working properly. That Interface board is then wired into my Konnected Pro on EXP1 and there is nothing in EXP2. However, after rebooting the Konnected Pro Alarm Panel it shows no sensors at all on the status page 'http://yourip:9123'.
Any thoughts? What should I see? There doesn't appear to be any configuration you can do on the app.