4 Wire Smoke Detector

I ordered my Konnect starter kit and I have been doing as much research as possible as well as analyzing my board. I think I have everything figured out except for the smoke detectors. It appears to be a 4 wire setup bridged over zones 7 and 8 (shows up as zone 8 on the wall display panels). However, I only see a black and red wire to those zones. Should there be two other wires someplace? 

My board is a Napco 1632, I will try to post pictures. 

Attached pictures of my existing system

I wired the R and B to zone 6 on Konnected (not sure what else I should have done) but now it just shows a smoke detected signal. I assume these are input lines and dont affect the operation of the smoke detectors but I want to make sure I am not messing anything up before disconnecting them. 

I'm struggling with similar wiring challenges. On my system, red and black were used to send power to the smokes.  Green / Yellow were the signal lines that went to the panel. 

You may need to swap normally closed for normally open in your HA system.

Please update here how the integration went. I have a Napco 1632 with 30 zones and interested to install Konnected.