Wiring interface with vista 20p for remote on/off question

I have wired an interface 2.0 with my ademco vista 20p and can monitor my alarm using my phone and the smartthings app. I need some help as how to wire it to be turned off and on remotely. I saw in a video that you needed programmable zones but I am not sure which those are, I don't see that. I have the relay module but am not sure exactly how to wire it and set it to do these things. 

So do I need 2 zones either being for armed/disarmed? And how exactly do you set up the relay module to arm/disarm with the interface v2 and smartthings?

Hi Derek,

Did you figure out the answer?

I have not