Motor Status Merlin 105MYQ

Konnected Garage Door Opener
,
1

Hi,

I have the GDO Blaq running 2026.8.2. I have wired in the Blaq to my door opener and am using Security+2.0. When I trigger a door open command, the door opens and the %openings in the loggs look good. But, I ave two issues:

  1. The motor status is always shown as ‘idle’

  2. When closing, after the first 5s warning, the logs show the door open % decreasing until about 72%, then the door actually starts closing.

Not sure why these are both happening.

2

Hi,

To confirm, I have the safety beams installed and the wiring completed as per the other AU/NZ threads, so just a bit stuck on this. I want to capture the motor running status for some automations.